When installing a deep well submersible pump, you need to pay attention to the installation steps. Only by following the relevant steps step by step can the pump operate normally underwater. So what are the installation steps of the deep well submersible pump? The editor of SEAKOO will introduce it to you through the article.

Deep well submersible pump

1. Before installing the deep well submersible pump, check whether the power supply voltage meets the specified use standards of the deep well submersible pump.

2. The diameter of the deep well should be slightly larger than the outer diameter of the deep well submersible pump unit, and the actual depth of the well should be measured before installation.

3. Check whether the good platform is suitable for installing the well cover and whether it can bear the weight of the deep well submersible pump unit and the supporting water outlet pipe.

4. Check whether the deep well submersible pump unit is well assembled, and remove the filter screen of the deep well submersible pump before installation.

5. Use a multimeter to check whether the three-phase wires of the deep well submersible pump are connected and whether the DC resistance is approximately balanced.

6. If the protection switch and control cabinet equipment are connected well, the soft-starting step-down control cabinet must be selected if the equipment is of high power. Recommended reading: Long-axis deep well submersible pump models and parameters

7. Install the rubber gasket of the water pipe to be upright, and evenly tighten the bolts without the water-saving pipe.

8. During installation, the cables, and the water pipes should be fastened with plastic tapes or water-resistant ropes on each section of the water pipes.

9. For the installed deep well submersible pump, check the insulation resistance and the connection of the three conductors from the switch in turn and then check the instrument and starting equipment.

10. After the deep well submersible pump runs for the first time for four hours, stop and quickly measure the thermal insulation resistance.

11. After the pump is stopped, it should be restarted after an interval of ten minutes. Do not start frequently to avoid damage to the motor and pump parts.

12. During use, it should be checked regularly. If the following phenomena are found, the machine should be stopped immediately, and then run after troubleshooting.

13. For the products packaged separately by the deep well submersible pump, when assembling and assembling, remove the check valve body of the pump part, and wipe the stop part of the pump connection.

14. The deep well submersible pump should be repaired outside the deep well once a year. Read more: How to install submersible pumps for wells

The above main steps are about the installation steps of the deep well submersible pump. Of course, during the installation, it is still necessary to have the technical support of the installation manual of the relevant enterprise or the relevant technical guidance and to provide more comprehensive guidance for the specific deep well submersible pump, in order to make the Normal installation for deep well diving. As a deep well submersible pump manufacturer in China, SEAKOO provides deep well submersible pumps with stable performance and long service life. If you are interested in deep well submersible pumps, please pay attention to our website.